User Manual

35-3001A-01-01 Methane Sample-Draw Detector • 11
8. Connect the wires to the applicable detector/transmitter terminal strip at the controller as
shown in Figure 5. Refer to the controller operator’s manual and the controller detector head
specification sheet for the 35-3001A-01-01 for detector/terminal strip connections specific to
the controller.
Figure 5: Wiring the Sample-Draw Detector to a Controller
9. If shielded cable is used, connect the cable’s drain wire to an available chassis (earth) ground at
the controller. RKI controllers typically have a ground stud that can be used to ground the
cable’s drain wire.
Not Used on
This Version
S
PWR / SIG
ZE RO
SP AN
OXY LEL/IR
Red
White
PATS201PATS201
AMP 1
AMP 1
OXY
LEL/ IR
Controller or
Recording
Device
+24VDC
AMP 2
4/20 Signal
- (DC Ground)
IR CH4
Sensor PCB
AMP 2
PATS101PATS101
W
LEL
GBR
Sensor
Current
148m A
IR CH4
Sensor
Green
Black