Instruction manual

8. CURRENT TRANSFORMER (CT) MONITOR
IMS01J04-E2
37
8.2 Setting on The PLC Side
Set the PLC as follows. (Recommend setting example)
Item Description
Serial communication mode High-order link
Unit number (Model number) 0
Start bit 1
Data bit 7
Stop bit 2
Parity bit Even
Transmission speed Set the same as SR Mini HG SYSTEM
I/O port selection RS-422A
Synchronization selection Internal synchronization
CTS selection 0 V (always ON)
5 V supply OFF
Termination resistor Termination resistor is inserted
The setting item varies depending on the PLC. The details of the setting procedure for the
PLC please also read the instruction manual for the used PLC.