Instruction manual

8. CURRENT TRANSFORMER (CT) MONITOR
IMS01J04-E2
35
 Protocol selection and communication setting
Match the setting of data bit configuration, communication speed and communication protocol with
the PLC communication specification by COM.PORT1/COM.PORT2 setting switch (SW2).
Setting example to recommend is shown in the following.
COM.PORT1/COM.PORT2
setting switch (SW2)
Data bit configuration
Communication speed
(Set the same as PLC.)
Communication protocol
Factory set value: All OFF
1 87 6 54 32
ON
H-PCP-J module
Right side view
 Data bit configuration
SW2
Data bit configuration
1 2
ON ON Data 7-bit, Even parity, Stop 2-bit
 Communication speed Set the same as PLC.
SW2
Communication speed
3 4
OFF OFF 9600 bps
ON OFF 19200 bps
OFF ON 38400 bps
ON ON Don't set this one
 Protocol
SW2
Protocol
5 6 7 8
OFF ON ON OFF
OMRON SYSMAC series special protocol
[Current transformer (CT) monitor]