Specifications

11 - 14
11. CONNECTION TO GE PLC
11.5 PLC Side Setting
11.5.3 Connecting to IC693CMM311
 Communication settings
Make the communication settings using the
engineering tool.
When making the settings, set [Configuration Mode] on
the [Setting] tab of the engineering tool to "SNP only".
*1 Set to YES.
*2 Set to SLAVE.
*3 Set the communication format to be used.
(only when connecting to Port2)
*4 Set to NONE.
*5 Set to NONE.
*6 Set to LONG.
11.5.4 Connecting to IC697CMM711
 Communication settings
Make the communication settings using the
engineering tool.
When making the settings, set [Configuration Mode] on
the [Setting] tab of the engineering tool to "SNP only".
*1 Set to YES.
*2 Set to SLAVE.
*3 Set the communication format to be used.
(only when connecting to Port2)
*4 Set to NONE.
*5 Set to NONE.
*6 Set to LONG.
11.5.5 Station number setting
Set each station number so that no station number
overlaps.
The station number can be set without regard to the cable
connection order. There is no problem even if station
numbers are not consecutive.
(1) Direct specification
Specify the station No. of the PLC to be changed when
setting device.
POINTPOINTPOINT
PLC Station No. settings
Make sure to set a 2-digit number for the station No. of
the PLC to be monitored by the GOT.
Setting item PLC side setting
SNP Enable
*1
YES
SNP Mode
*2
Slave
Interface
*3
RS232, RS485
Data Rate 9600bps, 19200bps
Parity ODD, NONE, EVEN
Stop Bits 1bit, 2bits
Flow Control
*4
NONE
Turn Around Delay
*5
NONE
Timeout
*6
Long
Setting item PLC side setting
SNP Enable
*1
YES
SNP Mode
*2
Slave
Interface
*3
RS232, RS485
Data Rate 9600bps, 19200bps
Parity ODD, NONE, EVEN
Stop Bits 1bit, 2bits
Flow Control
*4
NONE
Turn Around Delay
*5
NONE
Timeout
*6
Long
Specification range
00 to 31
GOT
Station
No.3
Station
No.00
Station
No.15
Station
No.6
Examples of station number setting