Specifications

9 - 44
9. CONNECTION TO RKC TEMPERATURE CONTROLLER
9.5 Temperature Controller Side Setting
(3) Unit address settings
Set the unit address using the unit address setting
switch.
(4) Interval time settings
Configure the interval time setting using the RKC
communication setting tool (WinPCI).
After the communication is started, set as follows.
For the using method of RKC communication setting
tool, refer to the following.
RKC communication setting tool user's manual
9.5.4 Connecting to Z-COM
(1) Communication settings
*1 Adjust the settings with GOT settings.
*2 Select the unit address without overlapping with that of other
units.
(2) Setting DIP switches
Make the settings of transmission speed, data bit
configuration, communication protocol.
Setting item Set value
Instrument 0
CFG file ZTIO_rkc.cfg
Interval time 0 to 250ms
Module address setting switch
Setting range : 0 to F
Item Setting range
Communication speed
*1
9600bps, 19200bps, 38400bps
Communication protocol Host (MODBUS)
Data bit 8bits (fixed)
Parity None (fixed)
Stop bit 1bit (fixed)
Unit address
*2
0 to F
Interval time 0 to 250ms
Dip switch settings
valid / invalid
valid
Setting item Set value
Switch position
1 2 3 4 5 6 7 8
Communication
speed
(COM1)
9600bps ON OFF
19200bps OFF ON
38400bps ON ON
Communication
protocol
(COM1)
Host
(MODBUS)
ON
Communication
speed
(COM2)
9600bps OFF
19200bps ON
Communication
protocol
(COM2)
Host
(MODBUS)
ON OFF OFF
Dip
switch settings
valid / invalid
valid OFF
12345678
ON
OFF ON
COM.
PORT1
COM.
PORT2
COM.
PORT3
COM.
PORT4
COM1
COM2
Front side
Right side
Dip switch
COM