Specifications

6 - 24
6. CONNECTION TO YASKAWA PLC
6.3 Ethernet Connection
(2) Setting for the built-in MP2300S Ethernet and 218IF-
02
*1 Set the same the Node IP Address (Remote Station's IP
Address) and the Node Port (Remote Station's Port Number)
as the Local IP Address and the Local Port (Local Station's
Port Number) on the GOT side.
For the Local IP Address and the Local Port (Local Station's
Port Number) on the GOT side, refer to the following.
6.3.2 ■ Ethernet setting
Item Set value Range
Transmission
parameter
setting
IP Address [ ].[ ].[ ].[ ]
PLC side IP
address
Subnet Mask [ ].[ ].[ ].[ ]
PLC side setting
Gateway IP Address [ ].[ ].[ ].[ ]
Device name Arbitrary
Up to 16 one-byte
characters
Transmission
parameter
detailed setting
Engineering Port 256 to 65535
For a connection
with software
MPE720
Response Time 0
Not required for
communication
with GOT
Count of Retry
(Number of Retries)
0
Message
communication
of connection
parameter
setting
Connection Number 1
• Range of built-
in MP2300S
Ethernet: 1 to 4
• Range of
218IF-02: 1 to
20
Local Port 10500 256 to 65534
Node IP Address
*1
[ ].[ ].[ ].[ ]
IP address
of GOT
Node Port
*1
[ ]
Port No.
of GOT
Connection Type
UDP
(recommended)
TCP/UDP
Protocol Type
Extended
MEMOBUS
Extended
MEMOBUS,
MEMOBUS,
MELSEC,
None,
MODBUS/TCP
Code BIN RTU, BIN, ACII
Node Name Arbitrary
Up to 32 one-byte
characters
(16 two-byte
characters)