Specifications

5. CONNECTION TO FUJI TEMPERATURE CONTROLLER
5.5 Temperature Controller Side Setting
5 - 17
5
CONNECTION TO FUJI TEMPERATURE CONTROLLER
5.5.6 Connecting to interface
converter (KS-485)
 Communication settings
Make the communication settings using setting
switches.
*1 Set as necessary.
 Settings by switch
(1) Settings of transmission speed and terminating
resistor selection
*1 Set as necessary.
*2 Disabled.
5.5.7 Connecting to interface
converter (K3SC-10)
 Communication settings
Make the communication settings by operating the DIP
switch of the temperature controller.
*1 Make the same setting as that of GOT side.
 Settings by DIP switch
(1) Transmission speed settings
Item Set value
Transmission speed 9600bps
Terminating resistor
selection
*1
ON/OFF
Setting item Set value
Switch No.
1 2 3
4
*2
5
6
*2
7 8
Transmission
speed
9600bps ON OFF ON — ON —
Terminating
resistor
selection
*1
Enable ON ON
Disable OFF OFF
Rear
Front
Communication
setting switch
RS-232C
RS-485
Item Set value
Transmission speed
*1
9600bps, 19200bps, 38400bps
Data bit 8bits
Parity bit
*1
Odd, even, none
Stop bit 1bit
Communication Type
RS-232C RS-485
Echo back Without
Transmission speed
(bps)
Switch No.
1 2 3
9600 OFF OFF OFF
19200 ON OFF ON
38400 OFF ON ON
Terminal block
for RS-422/485
communication
Terminal block
for RS-232
communication
Front of K3SC-10 body Inside of K3SC-10 body
(When removing the front cover)
DIP switch
ON
SW
Set these
switches.