Specifications

4. CONNECTION TO FUJI PLC
4.2 Serial connection
4 - 19
4
CONNECTION TO FUJI PLC
(b) Setting of the station No.
Make the station No. using RS-485 station No.
switches.
(c) Connecting
terminating resistors
Turn ON/OFF the terminating resistor using RS-
485 terminating resistor ON/OFF switch.
(d) Setting of Transmission speed, Stop bit, Data bit,
Parity bit, Initializing method
Make the settings using the character configuration
switches.
 Connecting to FFU120B
(1) Communication settings
Make the communication settings using setting
switches.
*1 Adjust the settings with GOT settings.
*2 Avoid duplication of the station No. with any of the other
units.
*3 Turn ON the terminating switch of a general-purpose
interface module which will be a terminal.
(2) Settings by switch
Make the communication settings using each setting
switch.
(a) Setting of the MODE
Make the MODE settings using the MODE switch.
Station No.
0 to 99
Setting item Set value
Switch No.
1 2 3 4 5 6 7 8
Transmission
speed
9600bps ON OFF ON
19200bps
OFF ON ON
Stop bit
1bit ON
2bits
OFF
Data bit
7bits ON
8bits
OFF
Parity bit
Even ON
Odd
OFF
Done ON
None
OFF
Initializing
method
By switch ON
ON
Item Set value
MODE
Command-setting-type start-stop
synchronization, nonsequence format
Transmission speed
*1
9600bps, 19200bps
Data bit
*1
8bits or 7bits
Parity bit
*1
Even or Odd
Done, None
Stop bit
*1
1bit, 2bits
Initializing method By switch
Station No.
*1*2
0 to 99
Terminating resistor
*3
ON or OFF
MODE Switch position
Command-setting-type start-stop
synchronization, nonsequence
format
RS-232C 1:1
1
Command-setting-type start-stop
synchronization, nonsequence
format
RS-232C 1:1,
and RS-485 1:N
2
Command-setting-type start-stop
synchronization, nonsequence
format
RS-485 1:N
3
(Front view) (Rear view)
MODE switch
RS-485 station No.
switches
Terminator switch
Character configuration
switches