Instruction manual

6. REMOTE INPUT/OUTPUT AND REMOTE REGISTERS
IMSRM52-E5
43
6.3 Remote Registers
Remote registers (RWr and RWw) are numerical data.
“n” and “m” in the table are the addresses assigned to the master station by the station No.
setting. They can be calculated by the following equations:
n = (Station No. − 1) × 4 m = (Station No. − 1) × 4
As the calculation results are expressed in decimal digits, they are converted to hexadecimal
digits before substituted for “n” and “m” in the table.
Example: If the station No. of the H-LNK-A module is “1” or “5”
For station No. 1: Remote register RWrn to RWrn+F → RWr0 to RWrF
RWwm to RWwm+F → RWw0 to RWwF
For station No. 5: Remote register RWrn to RWrn+F → RWr10 to RWr1F
RWwm to RWwm+F → RWw10 to RWw1F
 List of remote register
(4 stations occupied, Temperature control 16 channels)
Direction: Remote device station (Temperature control unit) → Master station (PLC)
[RWr]
Address Details
RWrn
CH1
RWrn+1
CH2
RWrn+2
CH3
RWrn+3
CH4
RWrn+4
CH5
RWrn+5
CH6
RWrn+6
CH7 Data specified by the Extension No. setting for display [RYn0 to RYn5] *
RWrn+7
CH8 For details of the Extension No. and data, refer to 6.4 Extension No. (P. 45).
RWrn+8
CH9
RWrn+9
CH10
RWrn+A
CH11
RWrn+B
CH12
RWrn+C
CH13
RWrn+D
CH14
RWrn+E
CH15
RWrn+F
CH16
* For details, refer to page 44.