Instruction manual

6. REMOTE INPUT/OUTPUT AND REMOTE REGISTERS
IMSRM52-E5
34
Continued from the previous page.
Direction: Remote device station (Temperature control unit) → Master station (PLC)
[Remote input]
Address Details
RX(n+1)0
Unused
RX(n+1)1
Unused
RX(n+1)2
Unused
RX(n+1)3
Unused
RX(n+1)4
Unused
RX(n+1)5
Unused
RX(n+1)6
Unused
RX(n+1)7
Unused
RX(n+1)8
Unused
RX(n+1)9
Unused
RX(n+1)A
Unused
RX(n+1)B
Unused
RX(n+1)C
Unused
RX(n+1)D
Unused
RX(n+1)E
Unused
RX(n+1)F
Unused
RX(n+2)0
CH3 First alarm status (OFF: Alarm OFF, ON: Alarm ON)
RX(n+2)1
CH3 Second alarm status (OFF: Alarm OFF, ON: Alarm ON)
RX(n+2)2
CH3 Burnout alarm status (OFF: Alarm OFF, ON: Alarm ON)
RX(n+2)3
CH3 Heater break alarm (HBA) status (OFF: Alarm OFF, ON: Alarm ON)
RX(n+2)4
CH3 PID/AT transfer status (OFF: PID control, ON: AT <Autotuning> )
RX(n+2)5
CH4 First alarm status (OFF: Alarm OFF, ON: Alarm ON)
RX(n+2)6
CH4 Second alarm status (OFF: Alarm OFF, ON: Alarm ON)
RX(n+2)7
CH4 Burnout alarm status (OFF: Alarm OFF, ON: Alarm ON)
RX(n+2)8
CH4 Heater break alarm (HBA) status (OFF: Alarm OFF, ON: Alarm ON)
RX(n+2)9
CH4 PID/AT transfer status (OFF: PID control, ON: AT <Autotuning> )
RX(n+2)A
CH5 First alarm status (OFF: Alarm OFF, ON: Alarm ON)
RX(n+2)B
CH5 Second alarm status (OFF: Alarm OFF, ON: Alarm ON)
RX(n+2)C
CH5 Burnout alarm status (OFF: Alarm OFF, ON: Alarm ON)
RX(n+2)D
CH5 Heater break alarm (HBA) status (OFF: Alarm OFF, ON: Alarm ON)
RX(n+2)E
CH5 PID/AT transfer status (OFF: PID control, ON: AT <Autotuning> )
RX(n+2)F
CH6 First alarm status (OFF: Alarm OFF, ON: Alarm ON)
Continued on the next page.