Instruction manual

5. PREPARATION BEFORE OPERATION

IMSRM52-E5

5.2 Transmission Speed Setting

Set the transmission speed between the control unit (H-LNK-A module) and Control &

Communication Link master station using the transmission speed setting switch at the rear of the

H-LNK-A module. To do this, use a small blade screwdriver.

Set the same transmission speed to the Control & Communication Link master

station and all the H-LNK-A modules on the same line. Otherwise, a normal data link

cannot be made.

 Setting procedure

1. To separate the module mainframe from the mother block, press the bottom on the module, lifting

upward, to release connection.

2. Set the transmission speed using the transmission speed setting switch at the rear of the

H-LNK-A module.

z To prevent electric shock or instrument failure, always turn off the power

before setting the switch.

z To prevent electric shock or instrument failure, never touch any section other

than those instructed in this manual.

WARNING

Press bottom of module and lift upward to release

Mother block

Module mainframe

Upper

section

Mother block

Module mainframe

Lowe

section

Setting range: 0 to 4

(Factory set value: 0)

0: 156 Kbps

1: 625 Kbps

2: 2.5 Mbps

3: 5 Mbps

4: 10 Mbps

5 to 9: Setting inhibited

Transmission speed

setting switch

H-LNK-A module

(Rear)