Instruction manual

3. MOUNTING

IMSRM52-E5

 Mounting on the DIN rail

1. Remove the module mainframe from the mother block. For details of removing the module

mainframe, Refer to 3.5 Removing the Module Mainframe (P. 21).

2. Pull down the locking device at the bottom of the mother block.

(Figure 1)

For the H-PCP-G module, as there are two locking devices, pull down both of them.

3. Attach the top bracket of the mother block to the DIN rail and push the lower section into place

on the DIN rail. (Figure 2)

4. Slide the locking devices up to secure the mother block to the DIN rail. (Figure 3)

5. Slide connectors together to complete mother block installation. (Figure 4)

Figure 1

Locking device

Figure 2 Figure 3 Figure 4

When the mother block is mounted on the panel, 50 mm or more space is required at

the top and bottom of the mother block to attach the module mainframe.