Instruction manual

2. SPECIFICATIONS
IMSRM52-E5
13
2.2 H-LNK-A Module
Item Specifications
Module type Remote device station
No. of occupied stations 4 stations occupied
Transmission speed 0: 156 Kbps
1: 625 Kbps
2: 2.5 Mbps
3: 5 Mbps
4: 10 Mbps
Set by the rotary switch at the rear of the module.
The maximum transmission distance differs depending on the
transmission speed.
Maximum transmission
distance
156 Kbps:1200
m
625 Kbps: 900 m
2.5 Mbps: 400 m
5 Mbps: 160 m
10 Mbps: 100 m
Distance between stations 0.2 m or more
Station No. setting 1 to 61 (Setting other than this setting causes error.)
Set by the rotary switch at the front of the module.
LED display RUN lamp Green LED
Turned on: H-LNK-A module is not identified by
H-PCP-G module or H-LNK-A
module is being initialized.
Flashing 1: The module operates normally.
At intervals of 1 sec
(OFF for 0.5 sec/ON for 0.5 sec)
Flashing 2: − The transmission speed setting or
station No. setting switch was
changed during operation.
− CRC error now occurs.
At intervals of 0.5 sec
(OFF for 0.25 sec/ON for 0.25 sec)
LED display FAIL lamp Red LED
Turned off: When the module is normal
Turned on: When the module is abnormal
Flashing 2: Transmission speed setting or station
setting error now occurs.
At intervals of 0.5 sec
(OFF for 0.25 sec/ON for 0.25 sec)
TX lamp Yellow LED
Turned on: During data send
RX lamp Yellow LED
Turned on: During data receive
Continued on the next page.