Instruction manual

5. SETTINGS BEFORE OPERATION
IMS01J02-E1
48
5.2 Unit Address Setting
When each control unit is multi-drop connected to host computer, set the unit address of each control
unit using the unit address setting switch at the front of the H-PCP-J module. For this setting, use a
small blade screwdriver.
8
7
6
5
4
3
2
1
0
F
E
D
C
B
A
9
H-PCP-J module
Setting range:
0 to 15 (0 to F: hexadecimal)
Unit address setting switch
Set the unit address such that it is different to the other addresses on the same line.
Otherwise, problems or malfunction may result.