Instruction manual

5. SETTINGS BEFORE OPERATION
IMS01J02-E1
45
COM.PORT1/COM.PORT2 setting switch (SW2)
SW2
5 6 7 8
Protocol
OFF OFF OFF OFF
RKC communication protocol
(Based on ANSI X3.28 subcategory 2.5 B1)
See 6. RKC COMMUNICATION (P. 52).
ON OFF OFF OFF
Modbus protocol
See 7. MODBUS (P. 109).
OFF ON OFF OFF
MITSUBISHI MELSEC series special protocol
AnA/AnUCPU common command (QW/QR)
See PLC Communication Instruction Manual
[For MITSUBISHI PLC] (IMS01J03-E).
ON ON OFF OFF
MITSUBISHI MELSEC series special protocol
ACPU common command (WW/WR)
See PLC Communication Instruction Manual
[For MITSUBISHI PLC] (IMS01J03-E).
OFF OFF ON OFF
MITSUBISHI MELSEC series special protocol
AnA/AnUCPU common command (QW/QR)
[Current transformer (CT) monitor] *
See PLC Communication Instruction Manual
[For MITSUBISHI PLC] (IMS01J03-E).
ON OFF ON OFF
OMRON SYSMAC series special protocol
See PLC Communication Instruction Manual
[For OMRON PLC] (IMS01J04-E).
OFF ON ON OFF
OMRON SYSMAC series special protocol
[Current transformer (CT) monitor] *
See PLC Communication Instruction Manual
[For OMRON PLC] (IMS01J04-E).
ON ON ON OFF
SHARP JW50H/70H/100H and JW30H special protocol
Computer link (command mode)
See PLC Communication Instruction Manual
[For SHARP PLC] (IMS01J05-E).
OFF OFF OFF ON
ON OFF OFF ON
Do not set this one
OFF ON OFF ON
LG MASTER-K series special protocol
See PLC Communication Instruction Manual
[For LG PLC] (IMS01J06-E).
ON ON OFF ON
LG GLOFA-GM series special protocol
See PLC Communication Instruction Manual
[For LG PLC] (IMS01J06-E).
OFF OFF ON ON
ON OFF ON ON
OFF ON ON ON
ON ON ON ON
Do not set this one
Factory set value: RKC communication protocol
* This is the dedicated to current transformer (CT) monitor. This protocol cannot be used
together with other protocols on the same line.