Specifications

2. DETAILS OF PARAMETER SETTING
IMR01H03-E4
16
!"
!"!"
!"
When changed parameter of alarm type selection
When change alarm 1 type and alarm 2 type, all the set value of a list shown below is initialized. Set it
in value to use once again.
Mode Description Default value
TC input RTD input Voltage input
Alarm 1 hold action 0 (Without alarm hold action)
Alarm 1 differential gap 2 °C [°F] 2.0 °C [°F] 0.2 % of span
Alarm 1 action at input error 0 (Without action at input error)
Alarm 2 hold action 0 (Without alarm hold action)
Engineering Alarm 2 differential gap 2 °C [°F] 2.0 °C [°F] 0.2 % of span
mode Alarm 2 action at input error 0 (Without action at input error)
Alarm 3 hold action 0 (Without alarm hold action)
Alarm 3 differential gap 2 °C [°F] 2.0 °C [°F] 0.2 % of span
Alarm 3 action at input error 0 (Without action at input error)
Setup setting Heater break alarm 1 OFF
mode Heater break alarm 2 * OFF
Control loop break alarm 8.0 minutes
Parameter
Control loop break alarm
deadband
0 °C [°F] 0.0 °C [°F] 0.0 %
setting mode Alarm 1 50 °C [°F] 50.0 °C [°F] 5.0 % of span
Alarm 2
Alarm 3
* In case of MA901, this item is not provided.