Specifications

1. PROCEDURE FOR INITIALIZATION
IMR01H03-E4
4
1.2 Procedure for Parameter Setting
!"
!"!"
!"
Flowchart of displaying parameter items
Display flowcharts in engineering mode are shown in the following.
[ : Press the SET key : Press the UP or DOWN key]
(AS1) (AHo1) (AH1) (ALT1) (AEo1)
(F21.)
Input type
selection
Display unit
selection
Decimal point
position setting
Setting limiter
(high limit) setting
Setting limiter
(low limit) setting
(F41.)
Alarm type
selectionAlarm 1
Alarm hold
action selection
Action selection at
input error
Alarm timer
setting
Alarm differential
gap setting
(InP) (UnIT) (PGdP) (SLH) (SLL)
PV
SV
(F10.)
(SPCH)
STOP display
selection
Return to the
F10
Return to the
F21
.
(F22.)
(CTr1)
CT ratio 1
selection
(CTr2)
CT ratio 2
selection
Return to the
F22
.
(dlSL)
Contact input
logic selection
(F24.)
Return to the
F24
.
Control output
logic selection 1
(F31.) (LGo1) (LGo2)
Control output
logic selection 2
Return to the
F31
.
(F32.)
(LGA)
Alarm output
logic selection
Return to the
F32
.
Return to the
F41
.
Any parameter whose channel number is
displayed can be set for each channel.
(Check the channel number on the
channel display of instrument.)
All of the channels can be
simultaneously set as the same value.
All the setting item is displayed regard
less of the contents of the instrument
specification.
A B