Instruction manual

4. MOUNTING
IMSRM15-E6
92
3. Connect the mother blocks together before tightening the screws on the panel.
(Customer must provide the set screws)
DIN rail mounting directions
1. Remove the module mainframe from the mother block. For details of removing the module
mainframe, refer to 4.7 Removing the Module Mainframe (P. 94).
2. Pull down the locking device at the bottom of the mother block. (*1)
For the double type, as there are two locking devices, pull down both of them.
3. Attach the top bracket of the mother block to the DIN rail and push the lower section into place
on the DIN rail. (*2)
4. Slide the locking devices up to secure the mother block to the DIN rail. (*3)
5. Slide connectors together to complete mother block installation. (*4)
Locking device
*1
*2
*3
*4
Single type mother block mounting
Tightening torque
Recommended value: 0.3 N
m (3 kgf cm)
When the mother block is mounted on the
panel, 50 mm or more space is required at the
top and bottom of the mother block to attach
the module mainframe.
M3 10
Mother block