Instruction manual

3. DESCRIPTION OF EACH MODULES
IMSRM15-E6
78
Status output function
This function is used to output the control unit action status other than the extension alarm output in
addition to the ordinary alarm output states (Alarm 1 status, etc.).
Event DO function
selection
Event DO corresponding channel
setting
Event DO mode
select setting
Unused (Manual mode)
Alarm 1 1 to 20 CH (H-TIO/H-CIO module)
Alarm 2 1 to 20 CH (H-TIO/H-CIO module)
Burnout 1 to 20 CH (H-TIO/H-CIO module)
Heater break alarm (HBA) 1 to 20 CH (H-TIO module)
AI alarm 1 1 to 40 CH (H-AI module)
AI alarm 2 1 to 40 CH (H-AI module)
Loop break alarm (LBA) 1 to 20 CH (H-TIO/H-CIO module)
PID/AT 1 CH
TI alarm 1 1 to 40 CH (H-TI module)
TI alarm 2 1 to 40 CH (H-TI module)
TI burnout 1 to 40 CH (H-TI module)
Event DI logic output status 1 to 40 CH (H-DI-B module)
Each event output can be assigned from the dedicated host computer via communication.
For details on event output selection, refer to SR Mini/SR Mini HG SYSTEM Supplementary
Information Initialize Settings [Extended Communications] (IMSRM07-E
).