Instruction manual

3. DESCRIPTION OF EACH MODULES
IMSRM15-E6
42
3.3.4 Settings before operation
Communication setting
Using the dip switches inside the H-PCP-A/B module, sets the communication speed and data configuration.
1. To separate the module mainframe from the mother block, press the bottom on the module, lifting
upward, to release connection.
2. Data configuration and communication speed can be set with the dip switches located in the
H-PCP-A/B module.
Top section
OFF
ON
4
3
2
1
Rear view of module mainframe with mother block removed
For the RKC communication/Ladder communication (Z-190)
1 2 Data configuration 3 4 Communication speed
OFF OFF 8-bit without parity OFF OFF 2400 bps
OFF ON 7-bit even parity OFF ON 4800 bps
ON OFF 7-bit odd parity ON OFF 9600 bps
ON ON Do not set this one ON ON 19200 bps
Factory set value: 8-bit without parity Factory set value: 9600 bps
When using the ladder communication, always set the data configuration to “8-bit without parity.”
For the Modbus (Z-1021) MEMOBUS (Z-1001)
1 2 Data configuration
OFF OFF Do not set this one
OFF ON 8-bit even parity
ON OFF 8-bit odd parity
ON ON 8-bit without parity
Factory set value: 8-bit without parity
To prevent electric shock or instrument failure, always turn off the power
before setting the switch.
To prevent electric shock or instrument failure, never touch any section other
than those instructed in this manual.
WARNING
!
Continued on the next page.
Mother block
Module mainframe
Upper
section
Mother block
Module mainframe
Lower
section
Press bottom of module
and lift upward to release