Instruction manual

2. SYSTEM CONFIGURATION
IMSRM15-E6
27
For the H-TIO module with CT input (optional),
the CT input is processed within the H-TIO
module. Therefore, it cannot be assigned to
other channels.
For the H-DO-A and H-DO-B modules,
duplicated alarms cannot be output. For the
H-DO-A and H-DO-B modules, the
functions assigned to each block consisting
of four H-DO module output points. Channel
numbers of the corresponding H-TIO module
are automatically set in order from the top
for each block of the functions assigned. For
this reason, duplicate alarms in the same
channel and of the same type cannot be
output. However, the above does not apply
to the H-DO-C module.
The input and output specification of the two channels H-TIO module are the same for both
channels.
[Example]
CT1
CT2
CT3
CT4
CT5
CT6
CT
Ch.A
Ch.B
Ch.C
Ch.D
Ch.E
Ch.F
Ch.G
(Assignment example)
Used in module
H-TIO-B modules
H-TIO-C module
H-CT module
Ch: Channel
(Assignment example)
CH1
CH2
CH3
CH4
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
CH1
CH2
CH3
CH4
TIO alarm 1
TIO alarm 2
TIO alarm 1
Heater break alarm
H-DO-A module
Relay contact output
Relay contact output
TC input
TC input
Relay contact output
Current output
TC input
RTD input