Instruction manual

1. OUTLINE

IMSRM15-E6

H-DO module (Digital output module) model code

(1) Type

A: 8 points output type

B: 4 points output type (Output signal is only relay contact output.)

C: 8 points event output type (Output signal is only open collector output.)

D: 16 points output type (Output signal is only open collector output.)

(2) Output signal

M: Relay contact output (Type A: 4 points/common, Type B: Independent common)

D: Open collector output (8 points/common)

The H-DO-C module cannot be used to the H-PCP-A/B module with the specification of

ladder communication.

Initial code

H-DO-A, H-DO-D

Block 2 (H-DO-A: Lower 4 points of terminal)

(H-DO-D: Lower 8 points of terminal)

Refer to DO allocation code table

Block 1 (H-DO-A: Upper 4 points of terminal)

(H-DO-D: Upper 8 points of terminal)

Refer to DO allocation code table

H-DO-B

- N

Block 1 (All points of terminal)

Refer to DO allocation code table

Above initial code is for H-DO-A, H-DO-B and H-DO-C type module. As for the allocation

of H-DO-C type module is done by the operation panel or host computer communication.

H-TI alarm 1 and alarm 2 is output from H-DO-C module.

H-DO- -

(1) (2)

N: Unused

1: Temperature alarm 1

2: Temperature alarm 2

3: Heater break alarm

4: Burnout alarm

5: AI alarm 1

6: AI alarm 2

7: Loop break alarm

DO allocation code table