Instruction manual

4. MOUNTING
IMSRM15-E6
94
4.6 Fixing of the Control Unit (For DIN Rail Mounting)
Mounting the fixture (accessory) to the both end of control unit.
1. Attach the bottom of the holding clips to the DIN rail and push the top section into place on the DIN
rail. (*1)
2. After the top of the holding clips is snugly attached to the top of the DIN rail. (*2)
3. Tighten the screw with a screwdriver. (*3)
*1
holding clips
*3
*2
DIN rail
holding clips
4.7 Removing the Module Mainframe
It detaches the module from the mother block that is mounted on DIN rail or a panel.
To separate the module mainframe from the mother block, press the bottom on the module, lifting
upward, to release connection.
The figures above are for the double type module. The single type module can also be
removed in the same way.
Mother block
Module mainframe
Upper
section
Mother block
Module mainframe
Lower
section
Press bottom of module
and lift upward to release