User`s manual

Temperature Controller MODBUS SIO Driver
GP-Pro EX Device/PLC Connection Manual
89
6.10 SR Mini HG(H-PCP-J) Series
This address can be specified as system data area.
Device Bit Address Word Address
32
bits
Remarks
Holding Register 0000.0-1DEE.F 0000-1DEE
*1
*1 When you write the bit address, the Display reads the word address corresponding to that of the
External Device first. Then, it changes the target bit address among the word data once read and
returns the word data to the External Device. Note that the correct data may not be written if you
change the word address value in the ladder program while the Display reads the data of the
External Device and returns it to the External Device.
• To set [Enable System Data Area] in the system area setting of GP-Pro EX may cause
malfunction. Do not set [Enable System Data Area].
• You can set only Read Area Size for the system data area available to use in the Temperature
Controller. Please refer to the GP-Pro EX Reference Manual for reading area size.
Cf. GP-Pro EX Reference Manual "Appendix 1.4 LS Area (only for direct access
method)"
• Please refer to the precautions on manual notation for icons in the table.
)
"Manual Symbols and Terminology"
• Even if you use the nonexistent address, read error may not be displayed. In this case, "0" is
retained for the read data. Note that the writing error is displayed.