User`s manual

Temperature Controller MODBUS SIO Driver
GP-Pro EX Device/PLC Connection Manual
2
Introduction
This manual describes how to connect the Display (GP3000 series) and the External Device (target Temperature
Controller).
In this manual, the connection procedure will be described by following the below sections:
1
System Configuration
This section shows the types of External
Devices which can be connected and SIO type.
)"1 System Configuration" (page 3)
2
Selection of External Device
Select a model (series) of the External Device
to be connected and connection method.
)
"2 Selection of External Device" (page 6)
3
Example of Communication Settings
This section shows setting examples for
communicating between the Display and
the External Device.
)
"3 Example of Communication Setting" (page
7)
4
Setup Items
This section describes communication
setup items on the Display.
Set communication settings of the Display
with GP-Pro EX or in off-line mode.
)
"4 Setup Items" (page 53)
5
Cable Diagram
This section shows cables and adapters
for connecting the Display and the
External Device.
)
"5 Cable Diagram" (page 58)
Operation