Instruction manual

3. SETTING FOR COMMUNICATION
IMCB03-E5
11
3.5 Data bit configuration setting
Set the data bit configuration during communication by using numerals from 0 to 5. Press the UP or
DOWN key to change the numeral.
Symbol Name Setting range Description
Factory set
value
Data bit
configuration
0 to 5
See *
A
Selects data bit configuration
during communication.
0
bIT
*
A
Setting Data bit [bit] Parity bit Stop bit [bit]
0 8 None 1
1 8 None 2
27 Even 1
37 Even 2
47 Odd 1
57 Odd 2
&"
Set the same data bit configuration to both the controller and connecting host computer.
&"
When the communication parameter was changed, always turn on the power again.
Otherwise, no communication is performed by using the changed value.
&"
If key operation is not performed for more than 1 minute without pressing the SET key
after the data bit configuration is set, the controller is automatically changed to PV/SV
display mode. In this case, the set data bit configuration returns to the value before the
setting is changed.
CAUTIONS