Installation guide

This CD-ROM includes all the driver files required by the LT/GLC/GP to communicate
with a CB, REX-F or LE100 Series (RKC protocol). This document assumes that one
or more of the following software applications are already installed on your PC. Please
note that if more than one of these applications are installed, the screen and data transfer
files included in this CD-ROM must be installed in each of those applications.
For information about the installation of the software, refer to that software's Operation
Manual.
 Software Applications
• LT Editor Ver.1.0 or later
• GP-PRO/PBIII for Windows Ver.5.0 or later
• Pro-server with Pro-Studio for Windows Ver.3.0 or later
*1
1) Confirm that the Screen Editor software is installed on your hard drive.
2) Double-click on the “cb_rkc.exe” file contained in the CD-ROM.
3) Once the set up program starts, follow the instructions given in the installation pro-
gram.
Installation
When using the CB, REX-F or LE100 Series (RKC protocol), select [RKC CB/
REX-F/LE100(RKC)] for the " PLC Type" .
When using GP-PRO/PBIII for Windows Ver.6.0 or later, click on the Device/PLC
area’s [other] selection and then click on [RKC CB/REX-F/LE100(RKC)].
*1 When using the Factory Gateway unit, GP-Web Ver. 1.0 or later, or GP-Viewer Ver.
1.0 or later, be sure to select the Pro-Server with Pro-Studio for Windows folder as
the “Destination Folder”.