Installation guide

GP-PRO/PBIII for Windows Ver. 6.1 PLC Connection Manual
Chapter 12 - Indicating Controllers
12-4-18
12.4 RKC INSTRUMENT INC. Controllers
CB Series / REX-F Series / LE100 Series (RKC protocol)


 CB Series
Device Bit Address Word Address
CB CB00000~CB0036F CB0000~CB0036 H/L
Comments


 REX-F Series


 LE100 Series
Device Bit Address Word Address
LE LE00000~LE0070F LE0000~LE0070 H/L
Comments
Device Bit Address Word Address
REX REX00000~REX0055F REX0000~REX0055 H/L
Comments
• GP/GLC/LT’s System Area (LS0 to LS19) Settings
The GP/GLC/LT’s system area (20 words) cannot be allocated to
the Controller’s own data area. When you are entering the sys-
tem area settings via the screen editor software or via the GP/
GLC/LT’s OFFLINE screen, be careful that you do not use the
Controller’s own data area.
!!
!!
!
Important
• Indicating Controller identifier data contains data to the right of the deci-
mal point. This decimal point data is handled by the GP/GLC/LT as fol-
lows:


 When reading out data
Data read out by the Indicating Controller is handled as integer data.
EX. With a value of 100.0:
Indicating Controller: 100.0
GP/GLC/LT: 1000
When displaying decimal point data in a numeric display, use the [Display
Data Format] area's [Decimal Places] setting. In this example, only the
first decimal place is used, so this setting should be "1". Now, the data will
be handled correctly.
EX. With a value of 100.0:
Indicating Controller: 100.0
GP/GLC/LT: 100.0
Note: