Instruction manual

4. SETTING FOR COMMUNICATION
IMCB14-E1
13



Setting procedure
Example: Setting the data configuration to 6: 8 data bits, even parity and 1 stop bit.
1. Go to the communication setting mode so that slave address, Add, is displayed. Press the SET
key until the data configuration symbol, bIT, appears.
Data configuration
2. Press the UP key to enter 6 at the first digit from the right.
3. Press the SET key to store the new data configuration. The display automatically goes to the next
communication parameter, InT.
SET
R/S
SV
PV
ALM2ALM1AT OUT2OUT1
SET
R/S
SV
PV
ALM2ALM1AT OUT2OUT1