Instruction manual

4. SETTING FOR COMMUNICATION

IMCB14-E1

4.5 Data Configuration Setting

The data configuration shown below is set with numbers from 1 to 3. To change the number of the

digit, press the UP or DOWN key.

Symbol Name Setting range Description

Factory set

value

Data

configuration

0, 6 or 7

See Data

Select data configuration

during communication

bIT Configuration

Table

Data configuration table

Setting Data bit Parity bit Stop bit

0 8 None 1

1 to 5 Do not set 1 to 5. Malfunction may result.

68 Even 1

78 Odd 1

Set the same data configuration for both the slave and the master.

When the communication parameter is changed, turn the power on and off again to refresh and

make the new value effective.

All data configuration settings must be stored by pressing the SET key. If changes are made

and the SET key is not pressed within one minute, the display will automatically return to the

PV/SV display mode and the data configuration will return to the value prior to set change.