Instruction manual

1. TRANSFER TO MODE

IMCB04-E2

1.2 End of initialization mode

• Transfer to "Initialize code selection" after each parameter is set.

‚ Simultaneously keep pressing both the SET and <R/S keys for 2 sec in the "Initialize code

selection" state to transfer to "PV/SV display mode."

ƒ Press the SET key for 2 sec in the "PV/SV display mode" state to transfer to parameter setting

mode.

„ Press the SET key to transfer to the set data lock function display.

… Press the <R/S key to brightly light the thousands digit on the set value (SV) display unit.

(See „ on P.1.)

† Press the DOWN key to set the numeric value corresponding to the thousands digit to "0" from "1."

SET

R/S

OUT1 OUT2

ALM1

ALM2

Set data lock function display

‡ Press the SET key to transfer to the next parameter. As a result, the "Initialization mode lock state"

setting becomes effective.

SET R/S

OUT1 OUT2

AT ALM1

ALM2

CT1 input display

*In the above figure, the CT1 input is displayed. However, the parameter to be displayed varies

depending on the specification.

Set value

0 : Initialization mode locked

1 : Initialization mode unlocked

Bright lighting :

Dim lighting :