Instruction manual

IMCB04-E2
27
3. COMMUNICATION INITIALIZE IDENTIFIER
n
nn
n
List of communication initialize identifiers
NOTES
l
Note that there are identifiers which cannot be communicated depending on the specification.
For details on the structure of communication data, see the instruction manual for
“
CB100/CB400/
CB500/CB700/CB900 communications
”
[IMCB03-E
¨
]
.
l
The number of digits is 6 for all data.
ID
: Identifier (RO : Read only R/W :
Read/write)
Name ID Data range Factory
set value
R/W
Initialization mode selection IO 0 : RO
1 : R/W
0R/W
Setting necessary code
[Cod]
IP 0 to 2 0 R/W
Input type selection
[SL1]
XI 0 to 15 See *1 To vary
depending on
the specificatio
n
R/W
Engineering unit and cooling type
selection
[SL2]
XQ
0 : °C (Air cooling)
1 : °F (Air cooling)
2 : °C (Water cooling)
3 : °F (Water cooling)
To vary
depending on
the specificatio
n
R/W
Heater break alarm (HBA),
control loop break alarm (LBA),
special specification, or
control loop break alarm (LBA)
output selection
[SL3]
LV 0 : No function provided
1 : HBA provided
2 : LBA provided, LBA is
output from “First alarm”
5 : HBA (Z-132 specification)
provided
10 : LBA provided, LBA is
output from “Second alarm”
To vary
depending on
the specificatio
n
R/W
First alarm (ALM1) type or
First alarm (ALM1) with hold action
selection
[SL4]
XA 0 to 15 See *2 To vary
depending on
the specificatio
n
R/W
Second alarm (ALM2) type or
Second alarm (ALM2) with hold
action selection
[SL5]
XB 0 to 15 See *2 To vary
depending on
the specificatio
n
R/W
Continued on the next page.