Instruction manual

2. PROCEDURE FOR SETTING

IMCB04-E2

(7) CTr (CT ratio setting)

Set the number of times that a wire is wound on to the hole of a CT.

Not displayed when there is no heater break alarm (HBA).

Setting range : 0 to 9999

Factory set value : CTL-6-P-N : 800

CTL-12-S56-10L-N : 1000

(8) dF (Digital filter setting)

Setting range : 0 to 100 sec (If "0" is set, the PV digital filter is turned off.)

Factory set value : 1

(9) STTM (Time factor assumed to be safe setting)

*Displayed when the self-tuning is provided.

This is the factor to adjust the reference time of establishing the stabilized state of a measured value. The

larger the set value, the longer the time until the measured value is stabilized.

As this factor is so adjusted that the self-tuning result optimum to most controlled-objects

is obtained, do not change it.

Setting range : 0 to 200

Factory set value : 100

CAUTION