Instruction manual

2. PROCEDURE FOR SETTING
IMCB04-E2
22
(3) PGdP (Setting the position of decimal point)
l
The set position of the decimal point is displayed only for current or voltage input.
l
Any digits other than the units digit are not used. As malfunction may result, do not
change any of these digits.
Factory set value : "0001"
Set
value
Description
0
No digit below decimal point
1 digit below decimal point
2
2 digits below decimal point
3
3 digits below decimal point
Setting the position
of
decimal point
0
Fixed
(4) Oh (Differential gap setting of ON/OFF action)
[Setting range]
•
TC and RTD inputs : 0 to 100 or 0.0 to 100.0
‚
Voltage and current inputs : 0.0 to 10.0 of span
[Factory set value]
•
TC and RTD inputs : 2 or 2.0
‚
Voltage and current inputs : 0.2
CAUTION