Instruction manual

2. PROCEDURE FOR SETTING
IMCB04-E2
5
2.2 Procedure for setting each parameter
[Example of changing the setting]
When the display unit shows "Engineering unit and cooling type selection (SL2)" in initialize code
"0," the following procedure is for changing the temperature unit from "°F" to "°C" or the cooling
method from "Water cooling" to "Air cooling."
• Change the instrument to the initialize code selection display.
(See "
1.1 Transfer to initialization mode
" on page 1.)
SET
R/S
OUT1 OUT2AT
ALM1
SV
PV
ALM2
‚ As "Engineering unit and cooling type selection (SL2)" belongs to the group of initialize code "0,"
do not change the initialize code (the units digit) but press the SET key to change to "Engineering
unit and cooling type selection (SL2)."
SET
R/S
OUT1 OUT2
AT
ALM1
SV
PV
ALM2
OUT1 OUT2
AT
ALM1
SV
PV
ALM2
R/S
SET
When the initialize code is set to "1" or "2," enter "1" or "2" in the units digit of the set
value (SV) display unit by pressing the UP or DOWN key.
Selecting and displaying
initialize code
Engineering unit (
°
C,
°
F)
and cooling type selection
Selecting and displaying
initialize code
NOTE
Please read this NOTE without fail.