User`s manual

Troubleshooting

Problem: The LEDs don’t flash when you hold down the Write

Button.

Solution: The Switch Gizmo did not receive a MIDI Program Change

message. First, verify that you have a valid MIDI connection. The MIDI

output of your MIDI controller should be connected to the MIDI input

of the Switch Gizmo by a MIDI cable that’s known to be working

correctly. The next most likely cause is that the Switch Gizmo is set to

a different MIDI channel than your MIDI controller. Check both

devices to insure that they’re set to the same channel. On the Switch

Gizmo, the MIDI channel is set to 1 by default and can be changed in

Setup Mode.

Problem: I’m trying to control my amplifier, and it’s not working or

behaving erratically.

Solution: This can happen if the Switch Gizmo is not configured

correctly for your amp. A switch may need to be configured for

momentary or inverted operation, for example. Check the Setup

Mode section for more information on how to configure. You can

also check contact us at RJM Music for assistance. We’d be happy to

help you out.