User`s manual

7
to select the current MIDI bank. Bank numbers above bank 1 are
ignored.
Bank selection is disabled by default. See the Setup Mode section for
information on how to enable bank selection.
Backing Up Your Settings: SysEx Dump
A SysEx (System Exclusive) data dump will send the current Switch
Gizmo system configuration out through the MIDI Thru/Out port.
You can then save this data to your computer, or copy the settings
directly to another Switch Gizmo.
Hold down the 1 and 2 buttons while powering up the Switch
Gizmo, and the Switch Gizmo will immediately send the SysEx Dump.
It only takes a couple of seconds to complete.
If you wish to copy settings from one Switch Gizmo to another,
connect the MIDI Thru/Out of the transmitting unit to the MIDI Input
of the receiving unit, then power up the transmitting unit while
holding down the 1 and 2 buttons. (Note that the receiving Switch
Gizmo must be powered on and not in setup mode.) The receiving
unit will display a progress bar graph on the LEDs. The transfer goes
very quickly, taking only a couple of seconds. In the case of an error,
the receiving unit will flash all LEDs 5 times.
Once the transfer completes, the receiving unit will reset, then return
to normal operating mode. The receiving unit now has an exact copy
of the transmitting unit’s settings.