User`s manual

MIDI Usage

The Switch Gizmo can receive MIDI messages from any MIDI

controller. You can store different switch settings for MIDI program

numbers 1 through 128 in MIDI banks 0 and 1. When a Program

Change message is received on the correct channel, the Switch

Gizmo will automatically recall the saved settings for the given

program number.

To set up for MIDI use, simply connect your MIDI controller to the

Switch Gizmo’s MIDI In jack. The Switch Gizmo is set for MIDI Channel

1 by default. Either make sure your MIDI controller is set up to

transmit commands on Channel 1, or use the Switch Gizmo’s setup

mode to change which MIDI channel the Switch Gizmo responds to.

See the Setup Mode section for more details.

To save a program setting, perform the following steps:

1. Using your MIDI controller, select a MIDI program number.

2. Using the Switch Gizmo buttons, select your amp’s channel

and functions.

3. Hold down the Write button on the Switch Gizmo until the

LEDs flash. This should take about 3 seconds.

That’s all it takes. You can repeat this for any or all of MIDI program

numbers 1 though 128.

If the lights don’t flash after a few seconds of holding down the Write

button, it means that your Switch Gizmo did not receive the MIDI

Program Change message. Check your MIDI cable connection, and

make sure that the MIDI controller and Switch Gizmo are set to the

same MIDI channel.

Now that your settings have been saved, you can recall your settings

by using your MIDI controller to send a Program Change message

again. The Switch Gizmo will call up your saved settings and set your