User`s manual

9
Backing Up Your Settings: SysEx Dump
A SysEx (System Exclusive) data dump will send the current Mini
Effect Gizmo system configuration out through the MIDI Thru/Out
port. You can then save this data to your computer, or copy the
settings directly to another Mini Effect Gizmo.
Hold down the Switch 5 button while powering up the Mini Effect
Gizmo, and the Mini Effect Gizmo will immediately send the SysEx
Dump. It only takes a couple of seconds to complete.
If you wish to copy settings from one Mini Effect Gizmo to another,
connect the MIDI Thru/Out of the transmitting unit to the MIDI Input
of the receiving unit, then power up the transmitting unit while
holding down the Switch 5 button. (Note that the receiving Mini
Effect Gizmo must be powered on and not in setup mode.) The
receiving unit will display a progress bar graph on the LEDs. The
transfer goes very quickly, taking only a couple of seconds. In the
case of an error, the receiving unit will flash all LEDs 5 times.
Once the transfer completes, the receiving unit will reset, then return
to normal operating mode. The receiving unit now has an exact copy
of the transmitting unit’s settings.
Factory Reset
To return the Mini Effect Gizmo to its factory state, hold the 1 and 4
buttons while you power it up. The lights should turn on briefly, then
turn off again. The Mini Effect Gizmo is now initialized and ready to
go.