User`s manual

41
Upd On Prst (Update on preset change) When set to “Off”, this button only changes state when it receives a MIDI
message from the device it is associated with, or when the button is pressed. When set to “On”, the button can also
change state when a new preset is selected. Typically, this is always turned on, but with certain devices like the Axe-Fx it
should be turned off.
TempoWhen set to “On”, this button is marked as a tap tempo button. These buttons flash with the currently set
tempo. If Upd On Prst is also turned on, this button will flash in time with the internal tempo clock. If Local Update is
turned off, this button will only flash when instructed by the connected device.
MomentaryWhen set to “On”, this button is momentaryit turns on when pressed and turns off when released.
When set to “Off”, this button is a normal (push on / push off) button.
OnMsgOnly - When set to “On”, this button will only send messages when it is turned on by a preset. When a preset
turns this button off, this button will not send any messages. This setting does not affect what happens when the user
actually presses the button.
Action Edit
The Action Edit screen allows you to edit the details of an action assigned to a button. These actions are performed
when an instant access button is pressed. An action can be a MIDI message that is sent, or something that affects the
system (change to a new button page, etc.)
Type Sets the type of this action. Possible values are: CC Toggle, CC Momen (Momentary), PC (Program Change), Note
and System.
Delete Action Deletes this action from the button it was assigned to.
Device Brings up the Device Select screen to allow you to select which device this action should be performed on.
When Type is set to System, this item is not displayed, and Function is shown instead
Function - Allows you to select the system function when editing a System action. See System type, below.
The next three buttons change their function based on the setting of the Type parameter:
CC Toggle or CC Momentary
CC NumberSets the continuous controller number for the action
On ValueSets the continuous controller value that is sent when the button is turned on
Off ValueSets the continuous controller value that is sent when the button is turned off
PC (Program Change)
PC On Sets the program number to be sent with the button is turned on
PC Off Sets the program number to be send when the button is turned off
The last of the three buttons is not active when editing a Program Change action.
Note
NoteSets the note number for the action
VelocitySets the note velocity for this action