User`s manual

6
Setup Examples
This example illustrates a simple configuration for controlling your amp and pedals. Four pedals are connected to
Audio Loops 1 through 4, and can be switched on and off using the Audio Loop buttons 1 through 4. The Amp 1 jack is
connected to the amplifier’s footswitch jack. The Function Switch buttons will control the amp’s channel and other
features (reverb, solo boost, etc.)
This is a two amp configuration – you can have either amp on, both amps on, or both amps off. When Audio Loop 5 is
on, Amp 1 is active, and when Audio Loop 6 is on, Amp 2 is active. An amp that is not active will have its input muted.
Both amplifier switching jacks are used. The amps can be switched simultaneously or independently, depending on
the amplifiers and amplifier interface cables being used. In a configuration like this, an isolation transformer may be
needed to eliminate noise caused by ground loops.
MIDI Thru
Buffer In
Buffer Out Input
R
et urn 1
S
en d 1
R
et urn 2
S
en d 2
R
et urn 3
S
en d 3
R
et urn 4
S
en d 4
Out p ut
S
end 5/NC
In 5
R
et urn 5
Out 5/N O
S
end 6/NC
In 6
S
end 7/NC
In 7
S
end 8/NC
In 8
R
et urn 6
Out 6/N O
R
et urn 7
Out 7/N O
R
et urn 8
Out 8/N O
Power
9VAC only!
MIDI In
Amp 1 Amp 2
From Fron t
R
JM Music Technology, Inc. www.rjmmusic.com
MIDI Out
Tuner Out
Guitar connects to input on front panel
IN OUT
IN OUT
IN OUT
IN OUT
Amp Input
From MIDI Controller Out
To Footswitch Jack
To Footswitch Jack
Amp Input
Setup 2 – Four FX Pedals, Two Amps
Setup 1 – Four FX Pedals, One Amplifier
MIDI Thru
Buffer In
Buffer Out Input
R
et urn 1
S
en d 1
R
et urn 2
S
en d 2
R
et urn 3
S
en d 3
R
et urn 4
S
en d 4
Ou t put
S
end 5/NC
In 5
R
et urn 5
Out 5/NO
S
end 6/ NC
In 6
S
end 7/ NC
In 7
S
end 8/ NC
In 8
R
et urn 6
Out 6/NO
R
et urn 7
Out 7/NO
R
et urn 8
Out 8/NO
Power
9VAC only!
MIDI In
Amp 1 Amp 2
From Front
R
JM Music Technology, Inc. ww w.rjmmusic.com
MIDI Out
Tuner Out
Guitar connects to input on front panel
IN O U T
IN O U T
IN O U T
IN O U T
IN O U T
IN O U T
IN O U T
IN O U T
From MIDI Controller Out
To Amplifier InputTo Tuner
To Footswitch Jack