User`s manual

Sets the MIDI channel and CC number for the seventh Continuous Controller destination. Press 2 / Program/CC

Number to select the CC number and 5 / MIDI Ch to select the MIDI Channel.

CC8 - Continuous Controller Destination #8

(MIDI Ch range: CH01 - CH16, CH-- (CC8 disabled) , Default value: CH--)

(CC number range: c000 - c127, Default range: c087)

Sets the MIDI channel and CC number for the eighth Continuous Controller destination. Press 2 / Program/CC Number

to select the CC number and 5 / MIDI Ch to select the MIDI Channel.

FNBA - Function Key Bank Support

(Enable range: On, OFF, Default value: On)

Turning this parameter on enables MIDI bank support for the Function key. Press 3 / CC On/Oﬀ to toggle this parameter

on or oﬀ. This needs to be on if you plan to use the Alternate Preset feature with other RJM Music products, but can be

turned oﬀ otherwise.

RENA - Remote Enable

(Enable range: On, OFF, Default value: OFF)

Turning this parameter on enables remote access mode, where two or more MasterMinds can be linked together and

synchronized. See the Remote Access section for more details. Press 3 / CC On/Oﬀ to toggle this parameter on or oﬀ. If

you’re connecting something other than a MasterMind to the Remote In port, this parameter should be set to OFF.

rCCh - MIDI Receive Channel

(MIDI Ch range: CH01 - CH16, CH-- (MIDI receive disabled) , Default value: CH--)

Sets the MIDI channel on which the MasterMind receives Program Change messages. Press 5 / MIDI Ch to select the

MIDI Channel. If this is enabled, a Program Change message coming in on the Remote In port will cause a preset to be

selected and the MasterMind will send all of the MIDI messages for that preset, just as if the preset was selected from

the front panel buttons.

SEND - MIDI Dump Send

(Yes/No selection: Press Bank Up (Yes) to send, Bank Down (No) to exit Setup Mode)

Pressing Bank Up when this parameter is selected will cause the MasterMind to send its conﬁguration data out the MIDI

Out port. If the MIDI Out port is connected to the MIDI In port of another MasterMind, the data will be transferred to the

MasterMind. The data can also be sent to a PC that has a MIDI interface and Sysex librarian software for backup

purposes.

InIt - Initialize

(Yes/No selection: Press Bank Up (Yes) to initialize, Bank Down (No) to exit Setup Mode)

Pressing Bank Up when this parameter is selected will cause the MasterMind to erase its memory, returning to the

factory default state. Be careful! This wipes the entire memory and there’s no way to restore your settings unless you

have previously backed them up to a PC or another MasterMind.

Preset Setup

Once you’ve ﬁnished Global Setup, you can set up each preset. In this mode, you set which Program Change number is

sent to each Program Change destination, and set which controller value is sent for each Continuous Controller for

every preset. You can also set up the Function button and Expression Pedal for each preset in this mode.