Legends Spec Coupe Kit Instructions

STEP 15 INSTALL BUSHINGS FROM BAG L3 IN EACH SIDE OF EACH FRONT WHEEL.LUBE THE AXLES WITH
LIGHT OIL, INSTALL THE TIRES AND RETAIN WITH LOCKNUTS FROM BAG L1. INSTALL THE REAR TIRES WITH
TWO 3/8 CAP SCREWS EACH FROM BAG L2.
STEP 13
STEP 13 INSTALL YOUR ESC AND RECEIVER ON TOP OF
THE BATTERY TRAY WITH SERVO TAPE. MAKE SURE YOU
LEAVE ROOM JUST BEHIND THE UPPER CHASSIS SPACER
FOR A TIE STRAP TO HOLD THE BATTERY PACK UNDER THE
TRAY. RUN YOUR ANTENNA WIRE THROUGH THE ANTENNA
TUBE AND USE TWO SMALL TIE STRAPS TO ATTACH THE
ANTENNA TUBE TO EITHER SIDE OF THE CHASSIS. PLUG
INYOUR RADIO WIRES AND BUNDLE THE EXTRA WIRE ON
TOP OF THE TRAY. WIRE YOUR ESC TO THE MOTOR AC-
CORDING TO THE MANUFACTURER’S INSTRUCTIONS.
STEP 14 TURN YOUR CHASSIS OVER AND INSTALL YOUR
BATTERY PACK WITH A LARGE TIE STRAP. INSTALL YOUR
RADIO SWITCH UNDER THE TRAY OR ON EITHER SIDE
PLATE SO YOU CAN TURN THE CAR ON AND OFF WITHOUT
REMOVING THE BODY. CHARGE YOUR BATTERY, TURN ON
YOUR RADIO AND ADJUST IT ACCORDING TO THE MANU-
FACTURER’S INSTRUCTIONS. MAKE SURE THE STEERING
AND THROTTLE WORK CORRECTLY. YOU SHOULD ALWAYS
UNPLUG YOUR BATTERY PACK WHEN YOU ARE THROUGH
RUNNING YOUR LEGENDS CAR.
STEP 14
STEP 16 PAINT YOUR LEGENDS BODY AS DESIRED .THERE ARE PAINTS MADE FOR LEXAN AVAILABLE AT
YOUR LOCAL HOBBY SHOP. SOME COMMERCIAL SPRAY PAINTS MADE FOR PLASTIC WILL STICK IF YOU
SCUFF THE INSIDE SURFACE WITH SCOTCHBRITE PADS. WE PROVIDE WINDOW MASKS, THE REST IS UP TO
YOU. AFTER PAINTING, TRIM THE BODY BY SCORING IT ON THE TRIM LINES WITH A SHARP HOBBY KNIFE
AND BENDING IT AWAY FROM THE CUT UNTIL IT SNAPS. DRILL THE PRE-MARKED MOUNT HOLES, THEN
PEEL THE PROTECTIVE FILM FROM THE OUTSIDE OF THE BODY BEFORE INSTALLING ANY DECALS. TEST
YOUR STEERING TO MAKE SURE THAT YOUR FRONT TIRES DO NOT RUB THE BODY. RE-TRIM IF NECES-
SARY.
THE NEXT THING YOU NEED TO DO IS TO GO OUT AND HAVE FUN RACING YOUR R/C LEGENDS CAR!
STEP 16
FOR MORE INFO: www.rjspeed.com
LEG 2-08 RJS
KEEP THE FUN IN RACING WITH R/C LEGENDS!!
3