RJS2014 RJ Speed Spec Modified Oval Kit Instructions

STEP 17 OPEN BAG L1B THREAD A 7206 THINNER NUT
ONTO EACH 5377 KINGPIN (SMOOTH ONE), INSERT IT
THROUGH THE FRONT ARM AND ATTACH WITH A 7207 LOCK-
NUT . HINT: BEFORE INSTALLING, HOLD THE KINGPIN BY
THE THREADED END IN A HAND DRILL AND USE VERY FINE
SANDPAPER, THEN METAL POLISH TO MAKE THE SURFACE
OF THE KINGPIN SMOOTHER.
STEP 17
STEP 18
STEP 18 PRESS A 5364 STUB AXLE PART WAY
INTO EACH 5351 STEERING BLOCK AS SHOWN, ADD
A 5221 E-CLIP AND PRESS IT IN THE REST OF THE
WAY. MAKE SURE THE HOLE IN THE STEERING
BLOCK IS CLEAN. HINT: RUN A 1/8 DRILL THROUGH
THE HOLE AND/OR TRIM THE OUTER EDGES OF THE
HOLES WITH A SHARP HOBBY KNIFE. MAKE SURE
THEY SLIDE FREELY ON THE KINGPINS. ADD A LIT-
TLE LIGHT GREASE OR SILICONE LUBE, INSTALL
THE STEERING BLOCKS, THEN THE SPRINGS, WASH-
ERS, AND E-CLIPS
STEP 19 OPEN BAG G2
PRESS A DIFF BALL INTO
EVERY OTHER HOLE IN
THE OUTER ROW OF
HOLES IN THE GEAR,
THEN LUBE THE BALLS
WITH LIGHT GREASE OR
SILICONE.
STEP 20 PRESS AN ADAPTOR INTO EACH SIDE OF THE
CHASSIS ASSEMBLY AND PRESS AN OILITE BUSHING
INTO EACH ONE. MAKE SURE THE ADAPTORS ARE IN THE
SAME WAY (WITH THE HOLE UP OR DOWN).
STEP 21 SLIDE A THIN WASHER ON THE AXLE AND IN-
SERT IT THROUGH THE REAR BUSHINGS. YOU MAY
HAVE TO MOVE IT AROUND A LITTLE TO GET IT
THROUGH THE FIRST TIME. HINT: GET YOUR AXLE
THROUGH THE BUSHINGS, ATTACH A DRILLTO ONE
END, LUBE THE BUSHINGS WITH LIGHT OIL AND RUN
IT FOR A WHILE TO BREAK THE BUSHINGS IN TO THE
SURFACE OF THE AXLE. MAKE SURE TO KEEP IT
OILED. AND SLIDE IT BACK AND FORTH A SMALL
AMOUNT WHILE RUNNING. ADD THE OTHER SPACERS
AND THE SET SCREW HUB. HINT: TIGHTEN THE SET-
SCREW LIGHTLY, REMOVE THE HUB AND GRIND OR
FILE A FLAT SPOT WHERE THE SET SCREW HITS THE
AXLE SO THE HUB WON’T SPIN ON THE AXLE UNDER
LOAD
STEP 20
4