RJS2032 RJ Speed 1-10 Classic Sprint Kit Instructions

STEP 12 INSTALL YOUR SERVO SAVER ON THE SERVO

AND ATTACH THE SERVO UNDER THE SERVO PLATE WITH

FOAM TAPE PROVIDED. GET THE SERVO SAVER AS CLOSE

TO THE CENTER AS POSSIBLE. MAKE SURE TO WIPE THE

SERVO AND SERVO PLATE WITH A DRY CLOTH BEFORE

APPLYING THE TAPE.

STEP 13 INSTALL THE STEERING LINKAGE FROM BAG H3. IN-

STALL A LONG LINK IN EACH STEERING BLOCK AND TWO

SHORT ONES IN THE SERVO SAVER. USE THE COLLARS AND

SET SCREWS TO ATTACH THE RODS TOGETHER AFTER ALIGN-

ING THE STEERING.

STEP 14 INSTALL YOUR SPEED CONTROL

AND RECEIVER ON TOP OF THE BATTERY

TRAY WITH FOAM TAPE. MAKE SURE TO

LEAVE ROOM TO USE TIE STRAPS IN A

COUPLE OF THE SLOTS AT THE EDGE OF

THE TRAY TO HOLD THE BATTERY PACK

UNDER IT.

STEP 15 IF YOU HAVE A RADIO THAT NEEDS IT, INSTALL THE

ANTENNA TUBE ON THE INSIDE OF THE CHASSIS THRU THE

SERVO PLATE WITH TWO SMALL TIE STRAPS. ROUTE YOUR AN-

TENNA WIRE THRU THE TUBE FROM THE BOTTOM. PLUG YOUR

SPEED CONTROL AND SERVO INTO THE RECEIVER, GATHER

ALL THE EXCESS WIRE (INCLUDING ANTENNA WIRE ) AND TAPE

IT IN PLACE NEAR THE RECEIVER. SOLDER OR CONNECT YOUR

SPEED CONTROL WIRES TO THE MOTOR.

YOU SHOULD CHARGE YOUR BATTERY AND TEST YOUR

RADIO FUNCTIONS AND MAKE ADJUSTMENTS NOW.

STEP 16 INSTALL YOUR BATTERY PACK UNDER THE

TRAY WITH A TIE STRAP. YOU SHOULD HAVE ROOM TO

MOUNT YOUR SWITCH NEXT TO IT WITH SERVO TAPE SO

YOU CAN TURN THE CAR ON AND OFF WITHOUT REMOV-

ING THE BODY. YOU CAN ALSO MOUNT THE SWITCH

NEXT TO THE SERVO IF YOU HAVE ROOM.

STEP 17 PRESS THE BUSHINGS FROM BAG H3 INTO EACH

SIDE OF EACH FRONT WHEEL FROM BAG L4. LUBE THE

FRONT AXLES WITH LIGHT OIL AND INSTALL THE FRONT

WHEELS. ADD LOCKNUTS FROM THE STEERING BAG TO

HOLD THEM ON. TIGHTEN THEM LIGHTLY, THEN BACK THEM

OFF UNTIL THE WHEELS SPIN FREELY.

INSTALL THE REAR TIRES FROM BAG L5 TO THE REAR

HUBS WITH TWO 3/8 CAP SCREWS EACH FROM THE DIFF

BAG. THE TIRES IN YOUR KIT MAY VARY FROM THE ONES

SHOWN. THEY WILL BE OF THE SAME OR BETTER QUALITY.