User's Manual
The device cannot
connect to a
smartphone or
computer
Wi-Fi password is incorrect
Enter the correct password
Wi-Fi signals are lost or
interrupted
Device is beyond Wi-Fi
coverage
Move binoculars and connect
device closer
Imaging quality is
poorer at low
temperature
At temperatures above 32℉, larger differences in temperature are
recorded between the object and background due to different heat
conductivity coefficients, resulting in better imageimage contrast than
at lower temperatures.
17. Warning
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between theequipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Body Operation
This device was tested for typical body-operations. To comply with RF exposure requirements,a minimum
separation distance of 0 mm must be maintained between the user’s body and the device, including the
antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any
metallic components. Body-accessories that do not meet these requirements may not comply with RF
exposure requirements and should be avoided. Use only the supplied or an approved antenna.