Instructions / Assembly

1. Please check this Product immediately to ensure that it has not been
damaged, broken, scratched or chipped.
2. Keep the product in its original box until you are ready to install it.
3. Before installation, please make sure this product is the correct model
and you have all the parts required for installation and use.
4. Verify if the packaging includes all essential parts such as :
- Vessel sink
- Pop up drain (optional / may be sold separately)
- Mounting ring (optional / may be sold separately)
5. We recommend that this product is installed by a qualified
professional plumber/ contractor.
6. Turn off water supply before commencing work, this should be done
at the isolating valves of inlet feeds if fitted or main stopcock
7. Please read these instructions carefully and keep it for future
reference.
Important
Rough-In Dimensions
Pop Up Drain & Mounting Ring Installation
(ONLY IF INCLUDED)
Finished Wall
1 3/4 Drain Hole
16 - 17
Countertop
5 3/4"
6 1/4"
34 Suggested
28 Suggested
Floor
Mounting Ring 1/2
Top View
2-3 Suggested
Fitting Line
For Wallmount Faucet
For Vessel Faucet
5 -6 Suggested
Side View
Glass Vessel Sink Installation Procedure
Step 1: Prepare counter top and drill a 1-3/4” hole for the drain at
the preferred position.
Step 2: Then place the vessel sink on the mounting ring or counter top as
shown above.
Vessel Sink
Mounting Ring
Counter Top
1 3/4
(Suggested)
Pop Up Drain & Mounting Ring
(ONLY IF INCLUDED)
Disassemble your pop up drain in the following order (only if included)
- Unscrew the tail piece and the drain nut
- Remove the hard washer and thick silicone washer; leave the
top thin silicone washer on.
Step 1: Place the mounting ring over the drain hole with O-ring rubber
base side facing down and the white rubber washer side facing
up and then gently set your sink on the top of the mounting ring.
Step 2: From above the counter top, insert the drain piece with the
thin silicone washer into 1-3/4” drain opening of your sink.
Step 3: From underneath the counter top, insert thick silicone washer
into the drain piece pushing the washer all the way up until it is
in contact with the counter top.
Step 4: Insert the hard washer onto the drain piece until it comes into
contact with the thick silicone washer.
Step 5: Screw and tighten the drain nut onto the drain piece until it
touches the hard washer.
Step 6: Screw and tighten the tail piece onto the drain piece.
Drain Piece
Mounting Ring
DO NOT OVER TIGHTEN THE DRAIN.
(Please Note: No tools are required. Installation should be done by hand.)
Mounting Ring
White Rubber Washer
Base
O-Ring rubber
Pop Up Drain
Drain Piece