Instruction manual

3
SAFETY
 DO NOT USE OUTSIDE DEISNG INTENT OR WITH EQUIPMENT THAT IS NOT RECOMMENDED BY THE MANUFACTURER.
 ALWAYS DISCONNECT THE AIR SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE OR ADJUSTMENT/FITTING OF NOSE EQUIPMENT
 DO NOT OPERATE A TOOL THAT IS DIRECTED TOWARDS ANY PERSON(S) OR WITH THE MANDREL CATCHER OFF THE TOOL
 ALL MODIFICATIONS CARRIED OUT ON THE TOOL WITHOUT EXPRESS WRITTEN CONSENT OF THE MANUFACTURER SHALL BE DONE SO AT
THE CUSTOMERS
’ SOLE RESPONSIBILITY
 REFER TO THIS MANUAL BEFORE ATTEMPTING ANY MAINTENANCE OPERATION. DO NOT DISASSEMBLE THIS TOOL BEFORE RFERING TO THIS
MANUAL
.
 AVOID EXCESSIVE CONTACT WITH HYDRAULIC OIL, AS SOON AS POSSIBLE WASH HANDS THOROUGHLY
 DO NOT EXCEED 7 BAR / 100 PSI INLET PRESSURE, THE USE OF A PRESSURE REGULATOR IS HIGHLY RECOMMENDED
 INSPECT THE TOOL USING PREVENTITIVE MAINTENANCE TECHNIQUES AT REUGULARLY SCHEDULED INTERVALS. INSPECT FOR DAMAGE AND
FUNCTION BY TRAINED COMPETANT PERSONEL
. REPLACE THE PNEUMATIC CYLINDER HOUSING OR HYDRAUILIC CYLINDER HOUSING
WHERNEVER THERE IS EVIDANEC OF IMPACT DAMAGE, CHIPPING, OR CRACKING.
 WEAR SAFETY GLASSES AND ADOPT FIRM FOOTING DURING OPERATION.
SPECIFICATIONS
The specifications and information contained in this manual are applicable only to the tool with which it was supplied.
Industrial Rivet & Fastener Co reserve the right to make any changes without notice as part of Industrial Rivet & Fastener Co
policy of continuous improvement.
.9” 12”
2.5”
11”
4”
SPECIFICATIONS FOR RK-8000M RIVET TOOL
Air Pressure 85-100psi Min/Max
Stroke 0.787 Inches Minimum
Pull Force 2,450 lbsF @90psi
Cycle Time 0.9 seconds Approximately
Noise Level 75 dB(A) Less than
Weight 3.3 lbs
Vibration
2.5m/s2
Less than
Hydraulic Oil Mobil DTFE 24
Nose Pieces 3/32, 1/8 , 5/32 ,3/16 All material rivets
Nose Pieces 3/16 ManoBolt