Instruction manual

10
OIL MATERIAL SAFETY DATA SHEET (MSDS)
Priming is ALWAYS necessary after the tool has been dismantled and prior to operating. It may also
be necessary to restore the full stroke after considerable use, when the stroke may be reduced and
fasteners are not fully placed by one operation of the trigger
Oil Details
The recommended oil for priming is Mobil DTE 24 or Hyspin VG32 available in 0.51 or one gallon
containers, or, you can use 30W hydraulic oil. Please see safety data below.
Mobil DTE 24 or Hyspin VG 32 Oil Safety Data
First Aid
SKIN:
Wash thoroughly with soap and water as soon as possible. Casual or short term contact requires no
immediate attention.
INGESTION:
Seek medical attention immediately. DO NOT induce vomiting.
EYES:
Irrigate immediately with water for several minutes. Although NOT a primary irritant, minor irritation
may occur following contact.
Fire
Flash point 232°C. Not classified as flammable.
Suitable extinguishing media: CO
2
, dry powder, foam or water fog. DO NOT use water jets.
Environment
WASTE DISPOSAL: Through authorized contractor to a licensed site. May be incinerated. Used
product may be sent for reclamation.
SPILLAGE: Prevent entry into drains, sewers, and water courses. Soak up with absorbent material.
Handling
Wear eye protection, impervious gloves (e.g. of PVC) and a plastic apron. Use in well ventilated
area.
Storage
No special precautions.
Priming Kit
To enable you to follow the priming procedure opposite, you will need to obtain a priming kit:
PRIMING KIT: RK-8000LS
PART NO DESCRIPTION
HO Mobil DTE 24
HO-B Refill Bottle