Operator`s manual
Table Of Contents
- RS 8000/8600 Getting Started Guide
- Notices
- Table of Contents
- 1 About This Guide
- 2 Introduction
- 3 Hardware Installation
- 3.1 Safety Considerations
- 3.2 Hardware Specifications
- 3.3 Installing the Hardware
- 3.3.1 Verifying Your Shipment
- 3.3.2 Installing the Chassis
- 3.3.3 Installing an AC Power Supply
- 3.3.4 Installing a DC Power Supply
- 3.3.5 Installing the Control Module
- 3.3.6 Installing the Switching Fabric Module (RS8600 only)
- 3.3.7 Installing Line Cards
- 3.3.8 Installing GBIC Modules into Line Cards
- 3.3.9 Installing ATM Physical Media Cards (PHYs)
- 3.3.10 Multi-rate WAN Line Card and WICs
- 3.3.11 SRP Line Cards and Bridge Mate Module
- 3.3.12 Installing SFP Transceivers
- 3.3.13 Attaching the Network Cables to Line Cards
- 4 Initial Configuration
- 4.1 Powering on the RS8000/8600
- 4.2 Starting the Command Line Interface
- 4.3 Configuration Changes and Saving the Configuration File
- 4.4 Setting the Basic System Information
- 4.5 Setting Up Passwords
- 4.6 Setting Up SNMP
- 4.7 Setting the DNS Domain Name and Address
- 4.8 Setting the SYSLOG Parameters
- 4.9 Using Redundant Control Modules
- 5 Managing Software
- Appendix A Troubleshooting
- Appendix B International SaFety Information
- Index
Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide 3-5
Hardware Installation Installing the Hardware
AC Power Supply Specifications
The following table lists the physical specifications for the RS 8000/8600 AC power supplies.
The following table lists the environmental specifications for the RS 8000/8600 AC power supplies.
Figure 3-2 Installing an AC power supply
Table 3-2 Physical Specifications for AC Power Supply
Specification RS 8000 RS 8600
Dimensions 11.00" (L) x 7.70" (W) x 2.55" (H) 12.15" (L) x 7.70" (W) x 5.05" (H)
Weight 6.5 lb (2.95 kg) 12.0 lb (5.45 kg)
Power Output 300 W 600 W
Voltage Range 100 to 125 V, 5 A
200 to 240V, 3 A
100 to 125 V, 10 A
200 to 240 V, 6 A
Frequency 50 to 60 Hz 50 to 60 Hz
Table 3-3 Environmental Specifications for AC Power Supply
Specification Measurement
Operating Temperature +5 to +40 °C (41 to 104 °F)
Non-operating temperature -30 to +73 °C (-22 to 164 °F)
Operating Humidity 15 to 90% (non-condensing)
G80-PAC
100-125~5A
200-240~3A
50-60 Hz
PWR